DoMultiRec setting

Caution

Please make sure that the inserts are indexed in the correct direction as shown below. Incorrect installation may result in tool damage and possible human injury.

Insert direction

Index the insert so that the arrow “<“ on the insert matches the arrow direction on the cutter body.

Note: Previous version of the insert and cutter have no engraved arrow “<“. In this case, please check the following points on the tool. Note that there is no difference in tool performance between the previous and current versions.

Peripheral edge

Center edge

Check points

Ensure that there is no gap in the contact between the insert and cutter body or the insert is not lifted in the pocket.

Peripheral edge

Center edge

ドゥー・マルチ・レック

警告

インサートの取り付けは正しく行ってください。
工具破損の原因になります。
下記を参考に取り付け状態を必ず確認してください。

インサートの向き

インサートのマーク(<) がボディのマークと同じ向きになるようにインサートを取り付けてください。

注意: 旧仕様のインサートにはマークがありません。
性能に差はありませんので、下記取り付け時の確認箇所を参考にご使用ください。

外周刃

中心刃

確認箇所

インサートを誤って取り付けると、カッタボディと隙間や段差が出来ます。
下図を参考に隙間、段差が無いことを確認してください。

外周刃

中心刃

Select country

US

This page includes IP2Location LITE data available from https://lite.ip2location.com.